More efficient condensation

Pressure related expansion with WITT highside float regulators increases the efficiency.

Limited footprints, low installation costs and energy-efficient components are the prerequisite for planning refrigeration systems today.
For the expansion of the condensed refrigerant it is often observed in practice, that several condenser outlets are conducted via a common pipeline to the expansion device.
However, in order to avoid performance losses in the condenser, this construction requires a high level of design and control effort.
Condensers with several heat exchange coils connected in parallel often work with a minimum of different condensation temperatures
TC.
If a surface, for example, exposed to more intense sunlight, this causes a pressure difference at the outlets. Already a deviation of the
TC between the heat exchange coils of only 0,1K causes an increase of approx. 0,7m pipework. These heights are often not available, so that a complicated and costly pipework and complex electrical control are the result.

Wijbenga B.V. in the Netherlands know the potential of WITT's high pressure float regulators and consistently recommends one seperate device per outlet of the condenser.
Wijbenga B.V. is one of the technological market leaders for the development of industrial refrigeration solutions 
in BeNeLux and sells WITT components and units.

Jeroen Schröer, Managing Director at Wijbenga tells in an interview:
"V-shape condensers use more space for condensation with the same footprint. Even with the noise emissions they have the advantage. In addition there is a tax benefit
in BeNeLux for condensers whose condensation temperature TC deviates by max. 10K from the outside temperature. This is very easy to realize with WITT float regulators in combination with a V-shape condenser. Since you can use smaller float regulators then, there is hardly any difference in price. "

When asked what exactly the advantage of high-pressure float regulators compared to electric expansion devices is, Mr. Schröer answers:
"Despite their compact design, the float regulators can contain a certain amount of condensed refrigerant and thus reliably avoid backflow into the condenser. They allow lower condensation temperatures and are maintenance free. This saves each 1K lower TC about 3% operating power. In addition, different condensation temperatures on the heat exchange coils can be neglected due to this design. Electronic expansion valves require either safe undercooling in the condenser or an extra high pressure receiver. The drive energy is also higher. "

Other large contractors of industrial refrigeration have also recognized the potential and are installing one WITT high-pressure float regulator in their refrigeration systems for each condenser outlet.

HR and HS - highside float regulator type HR4 on Thermofin V-shape condensors
Source: Thermofin

Part of your team!

This website uses cookies. By using the website you agree to the use of cookies. Data protection